Hussman IGFP-R3 Manual do Utilizador descarregar pdf (Página 5)

Rev. 0608

10. Use nger to smooth silicone as thin as possible at

masking tape on inside and outside of rear mullion

(apply additional silicone if necessary). Remove

tape applied on line #3.

Corner Wedges

Corner wedges are attached via front and rear camlocks.

Use a 7mm allen wrench to turn the locks. Do not

overtighten! Join the top by using a joint bracket (included

in joint kit) with 3/8” bolts.

Joint Trim

After cases have been leveled and joined, and refrigeration,

electrical, and wasted piping work completed, install the

splashguards. Fasten along the top edge, or center, with

#10 X 3/3” sheet metal screws.

DO NOT SEAL JOINT TRIM TO FLOOR!

Installation (Cont'd)

Scale Stand Installation Instructions

1.- Set Scale Stand to desire location

2.- Drill holes and screw in place

(with screws provided – Hex Tek S/S

10-16 X ½”)

Note: Use hole pattern

1 2 3 4 5 6 7 8 9 10 ... 32 33

Sem comentários

Hussman IGFP-R3 Manual do Utilizador Página 5